Minuteman® LineGuard™ Surge Suppressors
Need regular power line Surge Suppressors?
View MMS Surge Suppressors
Protection for Data Lines
Electrical transients can cause equipment to malfunction and can even have a catastrophic effect, inflicting severe damage to expensive devices, some of which may be mission critical. These electrical disturbances can enter into a network system through data lines that create a “back door” entrance to equipment. Normally, these electrical lines transmit data via very low voltage signals between devices, and by their very nature, data cables can have a direct route into equipment when higher voltage transients find their way onto data lines. Such damaging transients include electrostatic discharge, electromagnetic interference, and the most devastating of them all, lightning.
When damage to expensive equipment does occur from these types of anomalies, it is not covered under a manufacturer’s warranty. When you compare the cost of downtime and equipment replacement costs, these surge suppressors are an excellent investment.
Minuteman’s LineGuard products are UL listed and designed for fast, simple installation. All models are covered under Minuteman’s limited lifetime warranty, along with a $10,000 attached equipment protection plan.
LineGuard Features
- Solid-state, nanosecond response to over-voltage surges
- Lightning rated
- UL497B listed
- Good grounding is essential
- Lifetime warranty
- $10,000 attached equipment protection
- Interlocking wall-mount with single ground
- Fast, easy installation
LineGuard Models
- Protect analog cameras
- Protect CAT5 network (LAN/POE) connections - perfect for IP-based cameras
- Protect CAT6 network (LAN/POE) connections - perfect for IP-based cameras
Resources and Instructions
LineGuard MMS-PTZ-BNC
- Designed for analog cameras
- Uses BNC connector for video
- Terminal block for power (2 wires) and 4 wires for controls
LineGuard MMS-PTZ-BAL
- Designed for analog cameras
- Uses UTP to BNC connector for video
- Built-in balun Terminal block for power (2 wires) and 4 wires for controls
LineGuard MMS-PTZ-UTP
- Designed for analog cameras
- Uses UTP to UTP for video
- Terminal block for power (2 wires) and 4 wires for controls
LineGuard MMS-CAT5-LAN-RJ45
- Designed for CAT5 data lines
- Uses RJ-45 connectors
- For LAN network protection
- IP cameras
LineGuard MMS-CAT5-POE-RJ45
- Designed for CAT5 LAN/POE lines
- Uses RJ-45 connectors
- For LAN and POE protection
- IP cameras
- Not stocked, special order
LineGuard MMS-CAT6-LAN
- Designed for CAT6 data lines
- Uses punch-down block
- For LAN network protection
- IP cameras
- Not stocked, special order
LineGuard MMS-CAT6-POE
- Designed for CAT6 LAN/POE lines
- Uses punch-down block
- For LAN and POE protection
- IP cameras
- Will work with CAT5 POE
|
